MILLTECH fze UAE OMAN milltech@mail.com milltech.co
APPLICATIONS Eni i-Sigma top MS 10W-30 is a synthetic technology oil for lubricating new generation diesel
engines of vehicles equipped with exhaust gas post treatment systems operating under severe
operating conditions with fuel saving features.
This product allows the maximum oil change
intervals foreseen by the manufacturers.
It can also be used in diesel engines of stationary engines and in heavy duty gas engines.
CUSTOMER ADVANTAGES
• It is an engine oil that responds to the most sever performance levels required for heavy
traction, the result of a combination of a special synthetic formulation and new “low SAPSâ€
additive technology.
• To ensure the effectiveness and durability of post-treatment systems, the lubricant
formulation must not contain products which may have a negative impact and therefore
the content of certain components (Sulphated Ash, Phosphorus, Sulfur) must be controlled.
From this point of view, it adopts an innovative formulation technology precisely in
compliance with the chemical limits imposed by international specifications and
manufacturers.
• 'Fuel efficiency' allows much greater fuel savings than conventional lubricants. Engine life
and efficiency are ensured by the high wear protection (bore polishing), high detergency
and low evaporation losses.
• It has demonstrated excellent anti-wear properties in the tests required by the
manufacturers and by ACEA, in particular minimizing wear on the cylinders (bore polishing),
elastic bands, valves, etc. All metallic surfaces are effectively protected against wear and
corrosion by ensuring and maintaining the maximum engine efficiency over time, allowing
extended change and maintenance intervals.
SPECIFICATIONS
• ACEA E7, E9
• API CK-4
• Caterpillar ECF-3
• Cummins CES 20086
• Detroit Diesel 93K222
• Deutz DQC III-10 LA
• Ford WSS-M2C171-F1
• JASO DH-2-17
• MAN M 3575, M 3775
• MTU type 2.1
• MACK EO-S-4.5 (Approved)
• MB-Approval 228.31
• Renault VI RLD-3 (Approved)
• Volvo VDS-4.5 (Approved)
CHARACTERISTICS
Properties Method Unit Typical
Density at 15°C ASTM D 4052 kg/m³ 870
Viscosity at 100°C ASTM D 445 mm²/s 11.2
Viscosity at 40°C ASTM D 445 mm²/s 75.2
Viscosity Index ASTM D 2270 - 139
Viscosity at -25°C ASTM D 5293 mPa·s 6200
Flash point COC ASTM D 92 °C 235
Pour point ASTM D 5950 °C -45
B. N. ASTM D 2896 mg KOH/g 9.1
| Place of Origin | ITALY |
| Minimum Order Quantity | Not Given |
| Supply Ability | Not Given |
| Packaging Details | Not Given |
| Delivery Details | Not Given |
Not Given
